This technical article describes CNCGLASS multi-layer polyester insert, a polyethylene terephthalate based thermoplastic sheet made to sit inside a laminated safety-glass makeup together with CNCGLASS EVA laminating film. It is not a stand-alone interlayer. The insert is there to raise stiffness, impact reserve, and dimensional stability, and to provide a printable surface for ultraviolet-offset, silk-screen, or digital printing. A typical makeup places an outer glass pane, a sheet of EVA laminating film, the polyester insert, a second sheet of EVA film, and the second glass pane. Typical material figures given in the article include a density of about 1.2 g/cm³ and a glass-transition temperature of about 110 °C; those figures, like the process remarks, are typical indications that depend on a well-run laminating cycle, not a warranty for a particular makeup. The useful laminating range is 105 °C to 130 °C. The insert is supplied on reels in thicknesses from 0.2 mm to 0.8 mm and widths from 1,000 mm to 1,600 mm, wound on a 76 mm cardboard core; store below 30 °C and below 80 % relative humidity, and use within twelve months of delivery. The performance methods discussed in the article are commonly applied evaluations of the finished laminate. They are not presented as listings, notices of acceptance, or certificates held by CNCGLASS.